ClockInfo.com

Movement model number MT-13005, made in Japan. This movement has a number of buttons for setting the time and chime, below are scans of the four page instruction sheet. The movement dimensions are 4 inches by 3 7/16 inches. The instruction sheet has a date code 79.5.1 (May 1, 1979).

The back of the movement is labeled:

TOCHIGI TOKEI CO., LTD.
NO(0) JEWELS
UNADJUSTED
JAPAN

The movement has these numbers stamped in ink in the battery compartment:

13005
9031

The movement uses one D cell.

Related posts:

1. Speaker Mounting in Quartz Chime Clocks
2. Westclox Big Ben Chime Alarm Movement Photos
3. Alkaline Cells (Batteries) for Quartz Clocks
4. What to do when all the chime notes sound “thunky”
5. Picture of Urgos Grandfather Clock Movement Parts
6. 1950′s Regula Cuckoo Clock Movement

400 day clocks have a very thin flat wire (about 2 – 4 thousands of an inch thick), called the suspension spring or suspension wire, that the pendulum hangs from. You must be gentle with these clocks to avoid damaging the suspension spring.

This web page has some original 400 day clock instruction sheets:

400 Day clock instruction sheets

Before starting the clock, put it where it is to be located. Then unlock the pendulum (for Schatz miniature clocks and many Kundo clocks) or hang the pendulum on the pin at the lower end of the suspension spring. Level the clock so that the point on the bottom of the pendulum is near the center of the cup in the base. Some clocks have leveling feet that you can rotate, on those that don’t you can use paper or cardboard shims under the edge of the base.

Gently rotate the pendulum 1/2 turn and release it. During operation, the pendulum makes a slow motion of about one turn, first rotating one way, then the other, every 6 to 8 seconds. NEVER SPIN THE PENDULUM!

Earlier this year, a customer received a clock from me after repair, and it was working perfectly. Three days later, it stopped, and we could not figure out why. So he sent the clock back to me, and I found that the suspension spring, which should be flat, had over 100 twists in it! My customer was puzzled, but did some checking, and found that his cleaning lady’s grandson had spun the pendulum around rapidly! I replaced the suspension spring and the clock was as good as new.

Related posts:

1. Kern Miniature 400 Day Clock, Nickel Plated
2. Setting Suspension Fork Height on Schatz and Kundo Standard 400 Day Clocks
3. The Upper Suspension Block Must Fit the Saddle Correctly
4. 400 Day Clock Suspension Spring Sizes
5. 1950′s 400 Day Clocks Do Not Need to Have Bushings Installed!
6. My First 400 Day Clock